Skid-Steer Safety

As cities look for ways to improve efficiencies, and reduce sprain and strain injuries associated with manual material handling, a skid-steer is one piece of equipment they often turn to.  But as with any equipment operation, safety needs to be paramount. And while OSHA does not have a specific standards on skid-steers, employers have received citations for a serious violation under the General Duty Clause of the OSHA Standard (Section 5(a)(1)).

OSHA Citations related to Skid-Steers:

 

• Improper employee training on the safety features associated with the skid-steer loader

• Disabling of the interlock control system and was not functioning properly.

• Backup alarms did not functioning properly.

• Seatbelts had been removed from the skid-steer loaders.

• Failure to use an approved lift arm support device during servicing.

• Improperly maintaining the skid-steer loader according to the manufacturer's instructions.
• Employee's intentional bypassing of the safety systems of the skid-steer loader.

 

Skid-Steer General Safety Practices:

• Always read and understand the operator's manual before using the piece of equipment.

• Always lower the bucket or attachment so that it is flat on the ground.

• Do not attempt to activate the skid-steer loader’s controls from outside the operator's compartment.

• Do not leave the operator's seat while the engine is on. Never attempt to activate the controls unless properly seated with the seatbelt fastened and the seat bar (if equipped) lowered.

• Keep all body parts inside the cab while operating a skid-steer loader.

• Never modify, bypass, disable, or override safety systems.

• Never permit riders on the skid-steer loader, in the bucket or attachment, or in the operator's compartment unless the compartment is designed to accommodate a second rider.

• Establish a routine maintenance and inspection program in accordance with the manufacturer's recommendations, and use approved lift arm support device.

• Train personnel on the proper inspection, use, maintenance, and repair of skid-steer loaders.

Standard front step

Getting On/Off Equipment:

Side steps for larger buckets

Use three points of contact when getting in and out of skid steer. If using snow bucket or other large attachments, consider a side step for getting in and out of unit.

Side step for larger buckets

Hazards Associated with Operating Skid-Steer Loaders with Bypassed and/or Improperly Maintained Safety Devices http://www.osha.gov/dts/shib/shib011209.html   http://www.osha.gov/dts/shib/shib011209.html 

 

by Joe Ingebrand